Tarmac driveway cost is usually lower than resin or block paving, but the price you pay depends a great deal on whether the old drive has to come out or can simply be resurfaced. This guide brings together published UK prices for both, each credited to its source, along with the drainage and planning points worth settling before work starts.
Most price guides quote tarmac per square metre, and the figures below are copied as each source publishes them. Less.co.uk, updated in April 2026, gives £40 to £60 per m² for a full dig-out and re-lay, with an average of about £50. MyJobQuote, updated in October 2026, gives new tarmac at £45 to £100 per m² installed, while MyBuilder gives £45 to £80 per m² and adds £30 to £50 per m² for excavation and removal.
The spread between these ranges comes largely from what each guide counts as part of the job. Some include digging out and a new sub-base, while others price the surfacing and list groundwork as an extra. When you compare a quote with any of these figures, check first whether excavation, the sub-base, edging and waste removal are included.
| Type of work | Price per m² | Source |
|---|---|---|
| Full dig-out and re-lay | £40 to £60 | Less.co.uk (April 2026) |
| Overlay or resurfacing | £20 to £40 | Less.co.uk (April 2026) |
| New tarmac, installed | £45 to £100 | MyJobQuote (October 2026) |
| Tarmac resurfacing, labour and materials | £20 to £40 | MyJobQuote resurfacing guide (September 2026) |
| Tarmac, installed | £45 to £80 | MyBuilder |
| Excavation and removal, extra | £30 to £50 | MyBuilder |
| Coloured tarmac, extra | £10 to £20 | MyJobQuote (October 2026) |
Less.co.uk also gives a regional figure of £55 per m² for the South East, against £60 per m² in London. To turn these rates into a rough figure for your own drive, try our driveway cost calculator. It will not replace a site visit, but it helps you see whether a quote is in a sensible range.
Whole-driveway prices are easier to relate to your own home than rates per m². Less.co.uk treats a 40m² drive as a typical single-car driveway and an 80m² drive as a double, while MyJobQuote uses 30m², 60m² and 90m² for one car, two cars and larger drives. The table below sets their full dig-out and new tarmac figures side by side without combining them.
MyJobQuote gives an average of about £3,750 for a 60m² tarmac drive. Less.co.uk's own average for the same size is £3,000, which shows how far national guides can differ. All of these figures come from national guides, so local ground conditions, access and waste costs will move the final price either way.
| Size | Price | Source |
|---|---|---|
| 30m², full dig-out | £1,200 to £1,800 (average £1,500) | Less.co.uk (April 2026) |
| 40m², full dig-out | £1,600 to £2,400 (average £2,000) | Less.co.uk (April 2026) |
| 60m², full dig-out | £2,400 to £3,600 (average £3,000) | Less.co.uk (April 2026) |
| 80m², full dig-out | £3,200 to £4,800 (average £4,000) | Less.co.uk (April 2026) |
| 30m², new tarmac | £1,300 to £3,200 | MyJobQuote (October 2026) |
| 60m², new tarmac | £2,500 to £5,000 | MyJobQuote (October 2026) |
| 90m², new tarmac | £4,000 to £7,500 | MyJobQuote (October 2026) |
A new tarmac driveway normally means breaking out the old surface, digging down, laying and compacting a sub-base, then laying a binder course and a finer surface course on top. Resurfacing, sometimes called an overlay, keeps the existing base and lays a fresh layer of tarmac over it. Because there is far less digging and waste, resurfacing costs considerably less.
Less.co.uk gives an overlay at £20 to £40 per m², and £800 to £1,600 for a 40m² drive, against £1,600 to £2,400 for a full dig-out of the same size. MyJobQuote's resurfacing guide gives tarmac resurfacing at £20 to £40 per m², or £600 to £1,200 for 30m², £1,200 to £2,400 for 60m² and £1,800 to £3,600 for 90m². MyJobQuote's main tarmac guide gives a higher £50 to £70 per m² for resurfacing, which is a good reason to get more than one quote.
Resurfacing only works when the base underneath is sound. If the drive has deep potholes, sinking areas or tree roots lifting it, a new layer will soon show the same faults. An overlay also raises the surface level, which can matter next to door thresholds, garage floors and air bricks, so ask the installer how levels will be handled.
Standard tarmac is a solid surface, so rain runs off it rather than soaking in. That is why drainage needs thinking about at the start, especially on a front driveway. A well-laid drive is shaped with a slight fall so that water runs away from the house towards a drain, a soakaway or a lawn or border.
Porous asphalt is the permeable alternative. It is laid with an open structure over a free-draining base, so water can pass through the surface into the ground below. None of the price guides we use gives a separate price for permeable tarmac, so quotes vary and it is worth asking installers to price it alongside standard tarmac.
Drainage can also be added to a standard drive. Less.co.uk's resin driveway guide lists an ACO drainage channel at £30 to £60 per metre, and MyJobQuote's resin guide puts a soakaway at about £850. These figures come from resin pages, but the same drainage products are used under other driveway surfaces.
Because standard tarmac is impermeable, the planning rules for front gardens apply directly. GOV.UK guidance says that if the surface to be covered is more than 5 square metres, planning permission will be needed for traditional impermeable driveways that do not direct water to a permeable area. It names porous asphalt as one example of a permeable surface.
The Planning Portal says you will not need permission for a new or replacement driveway of any size that uses permeable surfacing, or where rainwater is directed to a lawn or border to drain naturally. These rights apply to houses, not flats or maisonettes, and they can be restricted in conservation areas, for listed buildings and where an Article 4 Direction applies. Check with your local planning authority before work begins, and read our driveway planning permission advice for more detail.
Several things push a tarmac quote up or down. Most of them only become clear once an installer has looked at the site and checked the ground. The list below covers the main ones.
Size has a smaller effect on the rate per m² than many people expect, because the fixed costs of bringing machinery and materials to site are spread over the whole area. Very small drives can therefore look expensive per m². If you are also widening access onto the road, our dropped kerb cost guide explains the separate council process.
A written quote after a site visit is the only reliable price for your drive. Ask each installer to state whether the price covers a full dig-out or a resurface, the depth of sub-base and tarmac, how water will drain and what edging is included. With those details side by side, it is much easier to compare like with like.
Sussex Driveway does not lay driveways itself. We connect homeowners with local driveway installers, and when you fill in our short form or call 01273 115520 you can get up to 3 free quotes with no obligation. You can read more about tarmac driveways before you decide.
Less.co.uk gives £40 to £60 per m² for a full dig-out and re-lay. MyJobQuote gives new tarmac at £45 to £100 per m² installed, and MyBuilder gives £45 to £80 per m² plus £30 to £50 per m² for excavation and removal.
MyJobQuote uses 60m² for a two-car drive and gives £2,500 to £5,000 for new tarmac, with an average of about £3,750. Less.co.uk gives £2,400 to £3,600 for a 60m² full dig-out.
Yes, because the existing base stays in place. Less.co.uk gives an overlay at £20 to £40 per m², against £40 to £60 per m² for a full dig-out. Resurfacing only suits a drive with a sound base.
Standard tarmac is impermeable, so a front driveway over 5 square metres needs permission unless rainwater is directed to a permeable area such as a lawn or border. Porous asphalt is treated as permeable. Rules differ for flats, conservation areas, listed buildings and Article 4 areas, so check with your council.
MyJobQuote says coloured tarmac adds £10 to £20 per m² to the price. Red is the most familiar option, and it can help define borders or parking bays.
Prices are published UK averages and include labour. Every job is different, so the quotes you receive will reflect your own property, access and materials.
Tell us about the job and up to 3 local driveway installers will be in touch with quotes. There is no charge and no obligation. Or call 01273 115520.
We use essential cookies to make this site work. With your permission, we would also like to use Google Analytics cookies to understand how people use the site so we can improve it. We do not use advertising cookies. You can change your mind at any time using the cookie settings button. Read our cookie policy for more information.